Make a Payment 

 Edging - Standard Profiles 

No.1 (Front Edging)

Simmons' standard containment edging for front edges and other edges which are open to view. This edging provides a 10mm dishing and a gloss finish to the outside face.

Maximum Length: 3m

No.3 (Rear Edging)

A 10mm high edging used against walls or around fume cupboard bases. Designed for use in conjunction with no.1 front edging.

Maximum Length: 3m

No.1G (Front Edging - DIN)

A deep front edging with a 7mm dishing, based on the standard DIN requirement for laboratory worktop containment edges.

Maximum Length: 3m

No. 3G (Rear Edging)

A 7mm high edging used against walls. Designed for use in conjunction with no.1G front edging.

Maximum Length: 3m

No.2 (Rear Edging)

A 15mm high edging, also used in the fabrication of fume cupboard bases.

Maximum Length: 3m

No.4 (Wide Rear Edging)

A 15mm high edging available in widths up to 165mm.

Maximum Length: 2.5m

No.4A (Wide Rear Edging)

A 10mm high edging available in widths up to 110mm.

Maximum Length: 2.5m

No.5 (Rear Upstand)

No.4A (Wide Rear Edging)

A 10mm high edging available in widths up to 110mm.

Maximum Length: 2.5m

No.6 (Plain Upstand)

Supplied loose with epoxy adhesive for on-site fitment, the plain upstand is available at any required height (H), commonly 50mm or 100mm.

Maximum Length: 2.7m