 |
|
|
|
. |
|
|
. |
|
|
. |
|
|
. |
|
|
. |
|
|
. |
|
|
. |
|
|
Make a Payment |
Copyright 2004 Simmons (Mouldings) Ltd.
All rights reserved
Revised 25/01/2006
|
Sinktops - Single Drainer |
|||
|
|
Single bowl single drainer sinktops feature a worktop, sink and drainer which is moulded in one section and as such is totally seamless. Sinktops incorporate a ribbed drainer area which slopes to an integrally moulded sink bowl. Single
drainer units are cast oversize and then cut to the required size, from a
minimum of 900 x 600mm up to a maximum of 1500 x 850mm. They are then
fitted with edging from Simmons standard range to make up the required
configuration.
When
ordering please clearly state overall size of unit, left or right hand
bowl and preferred position of bowl within the unit. Any tap holes that
are required should also be specified and dimensioned. If necessary you
should mark up one of the drawings below with your dimensional
requirements including tap holes required. |
||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||
